1. Raise and secure vehicle high enough to access the transmission.

2. Carefully remove the connector from the skip shift solenoid.

(Skip shift solenoid is located about halfway down the transmission case toward the top, on the drivers’ side.)

3. Install the black connector (see illustrations) from the Skip shift Eliminator Adaptor onto the skip shift solenoid/ (transmission end)

4. Take the original connector from the vehicle wiring harness and cap it off with the Skip Shift device separate cap.

5. Place wiring harness back into original location, tucked up along the transmission.  Tie up with zip ties to keep it out of the way.