CAMARO 2pc BILLET STYLE BACK UP LIGHT COVERS
PART# ACC-102030 - CMBB405
 INSTALLATION INSTRUCTIONS

PARTS INCLUDED:  2pc Stainless Billet Back Up Lights,  1-Adhesive Promoter Tube 

VERY IMPORTANT:
BEFORE YOU BEGIN YOU MUST FIRST PREP YOUR DASH/DOOR AREAS WHERE PIECES ARE GOING TO BE INSTALLED IN ORDER TO ALLOW ADHESION.
You can do this by scrubbing the entire area first with household isopropyl alcohol found in any stores hardware department.
 
NOTE: If these areas have been treated with armor all or any such surface protector; installation will NOT work unless these treatments have first been removed using special chemicals. 

1.  Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the areas of your dash/door that will be covered with your new stainless pieces. Allow a few seconds to dry. You have been provided with attachment tape test strips. Use one of these to test the tack. If it seams to stick well then you can proceed with your installation. If you can not get the test tape to stick please refer back to the special preparation instruction sheet and repeat those procedures. 

2.  Once properly cleaned take the piece of test strip tape (included) and remove a portion of the back red liner.  Stick the test tape strip to the area in your interior where you will be mounting your new trim.  Test several areas.  If it is tacky and sticks then proceed to the next step.  If it is not sticking very well in any of the spots you tested then re-clean the area until the test strip sticks to all areas.  If the test strip tape doesn't stick well neither will your new trim piece.

3.  Take the promoter (included) and swipe the area where you will be mounting your new trim.  This clear liquid will not damage your paint or interior.

4.  IMPORTANT:  Before you remove the rear red liner place each trim piece into position and check the fit and also get acquainted with just how each part sets in place.
If it doesn't fit right - STOP.  Call us.  It WILL be necessary to form a some trim parts by hand to CONFORM to the shape of your dash to insure a nice perfect fit without forcing the shape.
Once you are satisfied with the shape and fit - peel the rear red release liner off and carefully set into position.  Make any last tiny adjustments.  Now firmly press each piece into position.

 If any questions occur during installation please contact the manufacturer American Car Craft @ 727 861-1500 M-F.

NOTE:   EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to lightly dust your kit with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.

                             
                                           DO NOT GET WET FOR 24 HOURS.