Interior Parts that stick-on
General Instructions  (Please read before you mount your part)

For your interior part to stick securely you must properly prepare the surface.

1.  First wash the area where your part is to mounted with rubbing alcohol thoroughly.

2.  Now you will need to get some Isopropanol at your local hardware store.  Clean the surface using a rough pad with Isopropanol.

3.  Using test strip stick a small portion of the tape to the surface to see if it sticks.  Try several areas to be sure.
If the tape sticks to the whole area where you are going to mount your part.  If it doesn't stick to any of the areas you tried - repeat steps 1 and 2 again.

4.  Now  use the packet of 'promoter" included.  Take the sponge (or promoter pen) and wipe the area where the part is to be mounted.
Let dry for 5 minutes.  (this clear liquid will not damage your interior or exterior cars surface.  It simply prepares the surface for a good bond.)

5.  Before removing the backing from your new part - set the part in place where it is to be mounted. 
Move around slightly to get the exact fit you want.  Once you are comfortable with the position you want you are ready for the next step.

6.  Remove the back liner from your new part.  Hold it just over the exact area it is to be mounted.  Lower it slowly and gently set it
in place.  Do not push down yet.  Make any minor adjustments to placement.  Once set then start from the center and push firmly
in all directions to ensure a tight bond.

7.  Let sit for 2 hours.  You're done.

Exterior Parts that stick-on
General Instructions  (Please read before you mount your part)

For your exterior part to stick securely you must properly prepare the surface.

1.  First wash the area where your part is to mounted with soap and water thoroughly.

2.  Now you will need to get some Isopropanol at your local hardware store.  Clean the surface using a soft cloth with Isopropanol.

3.  Using test strip stick a small portion of the tape to the surface to see if it sticks.  Try several areas to be sure.
If the tape sticks to the whole area where you are going to mount your part.  If it doesn't stick to any of the areas you tried - repeat steps 1 and 2 again.

4.  Now  use the packet of 'promoter" included.  Take the sponge (or promoter pen) and wipe the area where the part is to be mounted.
Let dry for 5 minutes.  (this clear liquid will not damage your interior or exterior cars surface.  It simply prepares the surface for a good bond.)

5.  Before removing the backing from your new part - set the part in place where it is to be mounted. 
Move around slightly to get the exact fit you want.  Once you are comfortable with the position you want you are ready for the next step.

6.  Remove the back liner from your new part.  Hold it just over the exact area it is to be mounted. If necessary use a helper if it is a large part.
 Lower it slowly and gently set it in place.  Do not push down yet.  Make any minor adjustments to placement.  Once set then start from the center and push firmly
in all directions to ensure a tight bond.

7.  Let sit for 2 hours.  You're done.